CAT-5 VGA Extender Troubleshooting Steps

CAT-5 VGA Extender Troubleshooting Steps


Cat-5 VGA Extender is used in the situation where the screen supports VGA only and is deployed very far from the Media players. The cost for a 30 ft VGA cable is too high as compared to 30 ft Cat-5 cable
  • Media Player must be connected to the Cat-5 VGA Extender with a working VGA cable (Check VGA cable is not faulty).
  • Media Player and Cat 5 VGA Extender device must be powered (Check power on both Devices).
  • A Cat-5 Cable is connected to Cat 5 VGA Extenders and the other end goes to another device Cat-5 VGA Receiver (Check if the Cat 5 cable is not faulty and the Cat-5 Receiver device is not powered off).
  • A VGA Cable will be plugged into Cat-5 Receiver Device with the other end plugged into the Screen (Check if that VGA cable is not faulty).
Devices:
  1. Media player
  2. Cat-5 Extender
  3. Cat-5 Reciever
  4. LCD

    • Related Articles

    • WIFI Not Connecting, Keep saying Saved

      If your WiFi connection shows "Saved" instead of "Connected," try these troubleshooting steps: Ensure no Ethernet cable is attached to the media player if you’re trying to connect via WiFi. Double-check that you’re entering the correct WiFi password. ...

    • Signage PC X5 - Windows Boot Issue

      Here are the troubleshooting steps. First, type 'Exit' at the Shell prompt (at that error screen you shared with us), it should boot you into Windows. Once it boots into Windows then reboot the unit again and enter the BIOS. Next, we need to update ...

    • Unable to boot Built-in computer on Samsung 400 FPN-2

      There is a switch available at the back of Samsung 400 FPN-2, to power on LCD. Press the power button i.e. first button at the bottom of the LCD from left. The LCD comes up with "CMOS" and "Mac Address" message but the builtin computer didn't boot to ...

    • Convert to Studio Pro shows a white screen on browser

      If convert to studio pro button gives a white browser screen on next window, it means the flash player is not installed or enabled. Please follow below steps to fix it: For Chrome: Allow site to run flash automatically: ...

    • Cannot Preview the Campaign in Browser

      If the preview is not working in the browser it means the flash player is not installed or enabled. Please follow below steps to fix it. Chrome Browser: Allow site to run flash automatically:  https://support.google.com/chrome/answer/142064?hl=en ...