PC X5 Not Powering On - Red Light Showing

PC X5 Not Powering On - Red Light Showing

Here are the instructions to Reset the BIOS.

This helps to resolve the power issue with your Access unit.

How to open the Access casing

  • Hold the Access 4 with the HDMI port facing up. Use a spring tool to gently separate the two plastic parts. Be careful not to apply too much pressure to avoid breaking any clips or damaging the device.

image
image

  • Then, remove the metal shielding to expose the four Phillips screws. Use a screwdriver to unscrew the four screws and keep them aside in a safe place.

image
image

  • Flip the board to the other side and remove the metal shielding to expose a thin red and black cable connected to the board. Take care not to damage or pull the cable too hard. When unplugging the cable, wait for 10 seconds before reconnecting it to the board to ensure a clean connection.

image
image
image

  • Assemble every part back to its place and close the Access4 casing. Make sure that all the clips and screws are securely in place to avoid any rattling or looseness.
  • Finally, test the device to see if the problem persists. Check the HDMI port, power supply, and any other components to ensure that they are working properly.

    • Related Articles

    • How to Turn Off Ambient Light on PHILIPS Display

      Press the home button on remote ->  Ambilight -> ambilight Style -> Off.  Green Ambient light ON Green Ambient Light OFF

    • Signage PC X5 - Windows Boot Issue

      Here are the troubleshooting steps. First, type 'Exit' at the Shell prompt (at that error screen you shared with us), it should boot you into Windows. Once it boots into Windows then reboot the unit again and enter the BIOS. Next, we need to update ...

    • Installing Studio Pro Ver.6.2 on MAC OS X

      The Signage Studio Pro version release 6.2 has an air version for MAC Operating System.  1- Download and install Studio Pro for MAC OS x from below link: https://edisplay.egnyte.com/dl/G0kgnBV6pI 2- On the first startup Open the drop down and Select ...

    • WINDOWS OS X: How to clear Signage Studio Cache

      Click on "Start" go to "Run" and type in there a command "%APPDATA%" and press OK. Delete the Folders: "SignageStudio" & "SignageStudio.86EE3EEE54D7DB049D16E358CDC443F088917621.1" Note: The folder will have different alpha numeric characters at the ...

    • Yellow light/icon Connection Status under Stations Tab

      It means you're using the backup HTTP protocol Possible causes are:- - You have a Firewall within your Network or on the Router - You have a proxy installed - Enhanced network security settings - Other settings  It might take 5-10 minutes for any ...